Publicité
Les langues disponibles
Les langues disponibles
EN
Low Voltage Cutoff (LVC)
When a Li-Po battery is discharged below 3V per cell, it
will not hold a charge. The aircraft's ESC protects the flight
battery from over-discharge using Low Voltage Cutoff (LVC).
Once the battery discharges to 3V per cell, the LVC will
reduce the power to the motor in order to leave adequate
power to the receiver and servos to land the airplane.
When the motor power decreases, land the aircraft im-
mediately and replace or recharge the flight battery.
Always disconnect and remove the Li-Po battery from
the aircraft after each flight. Charge your Li-Po battery to
Transmitter Setup
If your transmitter allows it, enable the throttle cut feature.
Always engage throttle cut before approaching the aircraft.
Dual Rates
Low rate is recommended for the initial flights.
NOTICE: To ensure AS3X
do not lower rate values below 50%.
NOTICE: If oscillation occurs at high speed, refer to the
Troubleshooting Guide for more information.
1. Power ON your transmitter, click on scroll wheel, roll to System Setup and click the scroll wheel. Select YES.
2. Go to Model Select and choose Add New Model near the bottom of the list. Select Airplane Model Type by
choosing airplane image, select Create.
3. Set Model Name: Input a name for your model file.
4. Go to Aircraft Type and scroll to the wing selection, choose Wing: 1 Normal Tail: Normal
5. Select Main Screen, Click the scroll wheel to enter the Function List.
6. Go to D/R (Dual Rate) and Expo menu to set D/R and Expo.
7. Set Rates and Expo: Aileron
Set Switch: Switch F
Set High Rates: 100%, Expo 10% — Low Rates: 70%, Expo 5%
8. Set Rates and Expo: Elevator
Set Switch: Switch C
High Rates: 100%, Expo 10% — Low Rates 70%, Expo 5%
9. Set D/R (Dual Rate) and Expo: Rudder
Set Switch: Switch G
High Rates: 100%, Expo 10% — Low Rates 70%, Expo 5%
10. Set Throttle Cut; Switch: Switch H, Position: -100%
4
technology functions properly,
®
NX Series Transmitter Setup
about half capacity before storage. Make sure the battery
charge does not fall below 3V per cell. Failure to unplug a
connected battery will result in trickle discharge.
For your first flights, set your transmitter timer or a stop-
watch to 4 minutes. Adjust your timer for longer or shorter
flights once you have flown the model.
NOTICE: Repeated flying to LVC will damage the battery.
Exponential
After your initial flights, you may adjust the exponential
value to better suit your flying style.
Telemetry Alarms
Smart ESC : 12 Pole
Rx V : Min Rx V
Smart ESC : Low Voltage Alarm
Smart Battery : Startup Volt Minimum
UMX F-86 Sabre 30mm EDF
4.2V
3.4V
4.0V
Publicité
