Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting Guide
Problem
LED on receiver flashes
rapidly and aircraft will
not respond to transmit-
ter (after binding)
Control surface does not
move
Controls reversed
Motor loses power
Motor power quickly
decreases and increases
then motor loses power
Motor/ESC is not armed
after landing
Servo locks or freezes at
full travel
Possible Cause
Less than a 5-second wait between first
powering on transmitter and connecting flight
battery to aircraft
Aircraft bound to different model memory
(ModelMatch
radios only)
™
Flight battery/transmitter battery charge is
too low
Transmitter may have been bound to a differ-
ent model (or with a different DSM Protocol)
Aircraft or transmitter is too close to large
metal object, wireless source or another
transmitter
Control surface, control horn, linkage or
servo damage
Wire damaged or connections loose
Flight battery charge is low
Control linkage does not move freely
Transmitter settings reversed
Damage to motor or power components
Battery power is down to the point of receiver/
ESC Low Voltage Cutoff (LVC)
Over Current Protection (OCP) stops the
motor when the transmitter throttle is set high
and the propeller cannot turn
Travel adjust value is set above 100%, over-
driving the servo
Solution
Leaving transmitter on, disconnect and recon-
nect flight battery to aircraft
Select correct model memory on transmitter
and disconnect and reconnect flight battery to
aircraft
Replace/recharge batteries
Select the right transmitter or bind to the new
one
Move aircraft and transmitter to another
location and attempt linking again
Replace or repair damaged parts and adjust
controls
Do a check of wires and connections, connect
or replace as needed
Fully recharge flight battery
Make sure control linkage moves freely
Adjust controls on transmitter appropriately
Do a check of motor and power components for
damage (replace as needed)
Recharge flight battery or replace battery that is
no longer performing
Fully lower throttle and throttle trim to arm ESC
Set travel adjust to 100% or less and/or set sub-
trims to Zero and adjust linkages mechanically
EN
13
Publicité
