Horizon Hobby E-FLITE UMX F-86 Sabre 30mm EDF Manuel D'utilisation page 11

Power Components Service
Disassembly
CAUTION: DO NOT handle the propeller
while the flight battery is connected to the ESC.
Personal injury could result.
Motor
1. Remove the two M2 x 4mm self-tapping screws using
a Phillips #0 screwdriver from the fan and motor cover.
2. Disconnect the motor wire connector.
3. Remove the motor and fan.
4. Remove the M2 x 8mm screw from the fan using a
Phillips #0 screwdriver.
5. Remove the four M2 x 4mm counter-sunk machine
screws using a Phillips #0 screwdriver.
Assembly
Assemble in reverse order.
• Ensure the propeller adapter and motor mount are fully
connected to the motor.
Landing Gear
The aircraft landing gear comes installed from the factory.
Follow these steps to remove the nose and main landing
gear.
Removing the Nose Landing Gear
1. Remove the M1.2 x 4mm self-tapping screw using a
Phillips #0 screwdriver. The nose gear door will come
off.
2. Pull the nose gear from the fuselage, then rotate the
wheel 90 degrees to remove the wire from the slot.
Removing the Main Landing Gear
3. Use a small flat head screwdriver to gently pry the
wire over the retainer.
4. Pull the landing gear out of the retainer.
M2 x 4mm
Counter-Sunk
Machine Screw
EN
M2 x 4mm
Phillips Head
Self-Tapping
Screw
M2 x 8mm
Screw
11