Espressione FLEX 3-IN-1 Manuel D'instructions page 8

To program for water hardness:
1. When in Programming mode, press the double cup
button (3) to enter the water hardness settings.
2. Once pressed, take notice of the indicator lights,
which ones are on or off, and compare them with
the table below to interpret the current water
hardness setting. In the table below, an "X"
indicates a light is ON.
NOTE: The default water hardness setting is SOFT
WATER.
Water Hardness
Level*
Soft
<10° dh 10°
<18° fh 18°
<180mg/1 CaCo3
Semi-hard
dh-20° dh
fh-36° dh
180-300mg/1 CaCo3
Hard
>20° dh
>36° dh
360mg/1 CaCo3
3. The lights will now flash sequentially. Press the
button corresponding to the water hardness for your
area:
a. For soft water, press the single cup button
(2).
b. For semi-soft water, press the double cup
button (3).
c. For hard water, press the steam button (4).
Single Double Steam
Cup Cup Button
Button Button
X
X X
X X
Instruction Booklet
4. Once you have made your choice, the single cup
button (2) will flash quickly to confirm that your
selection was accepted, and the machine will beep
twice.
5. The machine automatically exits from the menu
when the water level has been set and is ready for
normal use.
Factory Reset Mode
To reset programming to factory settings:
1. Place a container under the milk frother (11).
2. Enter Programming mode.
3. Turn the hot water/steam knob (8) to the ON
position.
4. Press the single cup button (2).
5. The buttons will all flash at the same time,
indicating that all values have been reset to the
factory default settings.
6. When the single cup button (2) and the double
cup button (3) flash together, turn the hot
water/steam knob (8) to OFF.
X
Auto-off Function
This machine is designed to save energy. Consequently,
the appliance turns off automatically after 30 minutes of
inactivity. To return to normal operation, simply press
any button.
8 of 50
ESP-2016