Publicité
Les langues disponibles
Les langues disponibles
en-us Cooktop operation
8.16 Energy consumption display
This function indicates the total amount of energy con-
sumed between turning the cooktop on and turning it off
again.
Once cooktop is turned off, the energy consumption is dis-
played in kWh for 10 seconds, e.g. 1.08 kWh. The accu-
racy of the display depends on various factors such as the
voltage quality of the power supply.
You can activate or deactivate this function in the basic
settings menu.
8.18 Suitable cookware
Cookware that is suitable for induction cooking must have a ferromagnetic base, i.e. it must be attracted by a magnet. The
base must also match the size of the cooking zone. If cookware is not detected on a cooking zone, place it on the cooking
zone with the next smallest diameter.
Size and characteristics of the cookware
To correctly detect the cookware, take the size and the material of the cookware into consideration. All cookware bases
must be perfectly flat and smooth.
Use the feature Cookware test to check whether your cookware is suitable.
→ "Testing cookware suitability", Page 48
Cookware
Materials
Recommended cook-
ware
Stainless steel cook-
ware in a sandwich
design that distributes
the heat well.
Ferromagnetic cook-
ware made of enam-
eled steel, cast iron or
special induction cook-
ware made of stain-
less steel.
Suitable cookware
The base is not fully
ferromagnetic.
Cookware bases with
aluminum content.
Not suitable
Cookware made from
normal thin steel,
glass, clay, copper or
aluminum.
Notes
¡ Do not use adapter plates between the cooktop and the
cookware.
36
8.17 Power limitation
You can use the PowerManager function to set the total
power of the cooktop.
The cooktop is set at the factory; the cooktop's maximum
power is shown on the rating label. You can use this func-
tion to adjust the configuration to the requirements of each
electrical installation.
In order to not exceed this set value, the cooktop automat-
ically distributes the available power as needed between
the cooking zones that are switched on.
While this function is activated, the output of each cooking
zone may temporarily fall below the nominal value. In or-
der to not exceed this set value, the cooktop automatically
distributes the available power as needed between the
cooking zones that are switched on . The appliance regu-
lates and selects the highest power level automatically.
For more information, go to
→ "Basic settings", Page 34
Properties
This cookware distributes the heat evenly, heats up quickly, and en-
sures that it can be detected easily.
This cookware heats up quickly and ensures that it can be detected
easily.
If the ferromagnetic area is smaller than the base of the cookware, only
the area that is ferromagnetic heats up. As a result, the heat is not dis-
tributed evenly.
These reduce the ferromagnetic area, which means that less power is
emitted to the cookware. This cookware may not be sufficiently de-
tected or may not be detected at all, and therefore does not heat suffi-
ciently.
¡ Do not heat up empty cookware and do not use cook-
ware with a thin base, as they may become very hot.
Publicité
