Bosch HII8057U Manuel D'utilisation page 29

Deactivating the FlexInduction™ function
Select one of the two cooking zones of the flexible
1.
cooking zone.
Press flex join/split.
2.
a The flexible cooking zone is split into two separate
cooking zones.
Note: If the cooking zone is switched off, and then
switched back on again later, the flexible cooking zone is
reset to function as two independent cooking zones.
8.6 PowerMove® function
This function activates the entire flexible cooking zone,
and divides it into three cooking areas with different preset
power levels.
You can move an item of cookware during the cooking
process to another cooking area with a different power
level without making any settings.
Preset power levels
¡ Front area = power level
¡ Middle area = power level
¡ Back area = power level ⁠ .
General information for using this function:
¡ You can preset different power levels for each cooking
zone in the basic settings.
¡ Only use one item of cookware.
¡ If more than one item of cookware is detected on the
flexible cooking zone, the function is deactivated.
¡ When you move or lift up the cookware, the cooktop au-
tomatically starts searching and the power level of the
area in which the cookware was detected is set.
Cooking areas for PowerMove® function
The size of the cooking area depends on the cookware
used and whether it is positioned correctly.
Cooking areas for small pans
Cooking areas for large pans
Activating PowerMove®
Select one of the two cooking zones in the flexible cook-
1.
ing zone.
Press power move.
2.
a The indicator above power move lights up.
a The flexible cooking zone is activated as a joined cook-
ing zone.
a The power level in the area in which the cookware is lo-
cated lights up in the cooking zone display.
Changing the power level for PowerMove®
You can change the power levels for the individual cook-
ing areas during the cooking process.
Set the cookware down on the cooking area.
1.
Change the power level in the settings area.
2.
a Only the power level for the cooking area on which the
cookware is located is changed.
Deactivating PowerMove®
Press power move.
▶
a The indicator above power move goes out.
Notes
¡ If you set one of the cooking areas to , the function is
deactivated after a few seconds.
¡ When the function is deactivated, the power levels for
the three cooking areas are reset to the preset values.
8.7 Kitchen timer
You can use the Kitchen timer to set a time of up to
99 minutes.
The Kitchen timer is independent from other settings and
does not switch off a cooking zone.
You can also use the Kitchen timer when the cooktop is
turned off or the panel lock is activated.
Setting the kitchen timer - 800 Series
WARNING
Boilovers can cause smoke and some foods and oils may
catch fire if left on high temperature settings.
When using a timer, always supervise the cooktop.
▶
Do not allow anything to boil over or burn.
▶
Press Timer.
1.
and light up on the timer display.
a
Set the desired time in the settings area.
2.
a The time starts to count down.
a When the time has elapsed, a beep sounds.
and blink in the timer display.
a
Press Timer to stop the signals. After 10 seconds the
3.
signals stop automatically.
Cooktop operation en-us
29