Publicité
1
2
1. Locknut
A. Cable length
1. Contre-écrou
A. Longueur du câble
1. Contratuerca
A. Longitud del cable
1. Locknut
1. Contre-écrou
1. Contratuerca
A
2. Adjusting bolt
2. Boulon de réglage
2. Perno de ajuste
2. Adjusting nut
2. Écrou de réglage
2. Tuerca de ajuste
EBU14160
Parking brake adjustment
Parking brake adjustment may be required if the
parking brake does not hold properly. The cable
length A should be adjusted to 47–51 mm.
1. Loosen the locknut and the adjusting nut
on the brake cable below the fuel tank.
2. Fully loosen the locknut and the adjusting
bolt at the rear brake caliper.
3. Turn the adjusting nut on the brake cable
in direction a to increase the cable length
or in direction b to decrease the cable
length.
NOTE:
If the cable cannot be adjusted to specification,
consult a Yamaha dealer.
4. Tighten the locknut on the brake cable.
8-97
Publicité
