Publicité
KEY TO ALARM TABLE (Continued)
Alarm
Fault
The optional vacuum probe
E08
has failed or is not properly
connected
Maximum allowed
E09
temperature in chamber
exceeded
Electrical component
E10
compartment has overheated
Electronic circuit board
E11
diagnostics tripped
E13
E14
Setup error
E20
The washing cycle has been
E23
interrupted during the fi nal
sanitization stage
Automatic cleaning system
E26
failure
Remedy
Press the "Reset" button
Contact an authorized service
agent
The oven solves the problem
on its own
Contact an authorized service
agent
Contact an authorized service
agent
Press the reset button and
rinse the cooking chamber
thoroughly by hand
Check that no residues of
cleaning products have
been left inside the cooking
chamber
Combination Oven Installation and Operation Manual
Troubleshooting
Notes
Disconnect and reconnect the
vacuum probe before starting the
cooking cycle.
If the problem persists, Contact
an authorized service agent
The oven's functions are disabled
so no cooking cycles can be
carried out
The oven's functions are enabled
so cooking cycles can be carried
out
The oven's functions are disabled
so no cooking cycles can be
performed
The oven's functions are disabled
so no cooking cycles can be
performed
If the problem persists, Contact
an authorized service agent
If the problem persists, Contact
an authorized service agent
The oven's functions are enabled
so cooking cycles can be
performed
Section 8
45
Publicité
