Publicité
The appliance has been tested before being put into
service.
The information provided below is intended to assist
in the identifi cation and correction of any irregularities
and malfunctions which might occur during use.
Fault
The appliance does not
switch on
Cooking cycle does not
start or stops suddenly
ALARM IDENTIFICATION
If the problem or fault noticed is not among those
listed in the table, consult the "Key to Alarms"
table.
The information provided is intended to identify the
alarm signals which appear on display (7).
IMPORTANT _________________________
Press button (12) to reset the alarm and
the cooking cycle restarts automatically;
if this is not the case, press start key (16).
TROUBLESHOOTING
Cause
Fuse "blown"
Electronic circuit board damaged
Control board electronic circuit board
damaged
Alarm triggered
Safety or protection device (safety
thermostat or overload cutout) tripped
The user can solve some of these problems on their
own, but in most cases specifi c technical knowledge
or skill is required. More advanced troubleshooting
may need to be done by an authorized service agent.
Remedy
Replace the fuse (see page 39)
Contact an authorized service agent
Contact an authorized service agent
Consult the "Key to Alarms" table
Consult the "Key to Alarms" table +
Press device reset button
7
12
16
Combination Oven Installation and Operation Manual
Section 8
Troubleshooting
43
Publicité
