Publicité
Section 7
Parts Replacement
WARNING During the procedure, take
care not to touch the lamp directly; wear
protective gloves if necessary.
5. Reassemble everything when the operation is
complete.
Note: the appliance wiring diagram location can be
found on the "Safety Lable and Sign Location" page.
42 Combination Oven Installation and Operation Manual
DECOMMISSIONING THE APPLIANCE
WARNING Before performing any service
that involves electrical connection or dis-
connection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
When decommissioning the appliance, a series
of procedures must be carried out to ensure the
appliance and its components are no longer an
obstacle and are not easily accessible.
To ensure the appliance does not present a hazard
for people or the environment, all energy sources
(electricity, etc.) must be disconnected and made
unusable, and any liquids present must be drained
(lubricants, fl uids, etc.).
Place the appliance in a suitable area which is not
easily accessible with barriers to prevent anyone
from accessing it.
When scrapping, sort all components by material
type and dispose of them separately in accordance
with the relevant local recycling requirements and
regulations.
IMPORTANT _________________________
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the en-
vironment. Dispose of them in compliance
with all relevant laws, regulations, and lo-
cal recycling requirements.
Publicité
