Section 4
Handling and Installation
IMPORTANT _________________________
Cooking
chamber
rotate
in
a
clockwise
clockwise direction.
TESTING THE APPLIANCE
IMPORTANT _________________________
Before it is put into service, the system
must be tested to check the operating
conditions of every single component and
identify any malfunctions. In this stage, it
is important to check that all health and
safety requirements have been complied
with in full.
To test the system, make the following checks.
1. Turn on the water supply valve and make sure
the connection is watertight.
2. Make sure main (input) voltage is the same as
that of the appliance.
3. Check water pressure and adjust if necessary.
4. Check that the safety device is operating
properly.
5. Perform a cooking cycle without food to ensure
the appliance is operating properly.
After testing, train the user in all skills necessary
to ensure safe operation of the appliance, in
accordance with all legal requirements.
E
C
22 Combination Oven Installation and Operation Manual
convection
fan
and
counter-
A
D
ADJUSTMENTS
RECOMMENDATIONS FOR
can
ADJUSTMENTS
IMPORTANT _________________________
Before making any type of adjustment,
activate all the safety devices provided
and decide whether staff at work and
those in the vicinity should be informed. In
particular, turn off the water supply tap, cut
off the electricity supply using the master
switch and prevent access to all devices
that might cause unexpected health and
safety hazards if turned on.
ADJUSTING THE WATER PRESSURE
To perform this operation, proceed as follows.
1. Remove all screws and remove side panel (A).
2. Turn on the water supply valve (B).
3. Unscrew the ring nut (C).
4. Turn the cooking chamber water intake screw
(D) to bring the pressure reading on the pressure
gauge (E) to 14.5 PSI.
If the water pressure is too low, install a device
to increase the pressure.
5. Retighten ring nut (C).
6. Replace side panel (A), replace and tighten all
screws.
7. Turn water supply valve (B) to the OFF position
when the operation is complete.
B