Publicité
MAINTENANCE RECOMMENDATIONS
Keep
the
appliance
performing the scheduled maintenance procedures
recommended
by
maintenance will allow the best performance, a
longer working life and constant maintenance of
safety requirements.
WARNING
Before
servicing procedure, activate all the safety
devices
provided
workers and those in the vicinity should be
informed. In particular, turn off the water
supply valve, disable the electricity supply
using the master switch and prevent access
to all devices that might cause unexpected
health and safety hazards if turned on.
WARNING Before performing any service
that
involves
electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
At the end of each session of use and whenever
necessary, clean:
•
Condensation collection tank
•
Cooking chamber
•
Check air fi lter (if installed) located under the
appliance and clean it if it is dirty or obstructed
•
Appliance and the surrounding environment
WARNING At least once every 6 months
or, if meat or greasy foods are cooked
frequently, every 2 months clean the vent.
Every year, have skilled, authorized personnel
perform the following operations:
•
Cleaning of water intake fi lter
•
Cleaning of drain lines
•
General check of the appliance
•
Identify and replace worn parts
IMPORTANT _________________________
Record the yearly inspections.
MAINTENANCE
at
peak
effi ciency
the
manufacturer.
Performing
and
decide
whether
connection
IMPORTANT _________________________
by
Contact
representative or an authorized service
Proper
agent to perform maintenance and repairs.
ELECTRICAL LOCKOUT/TAGOUT
PROCEDURE
any
WARNING Before performing any service
that
involves
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
The Electrical LOCKOUT/TAGOUT Procedure is
used to protect personnel working on an electrical
or
appliance. Before performing any maintenance
or service that requires exposure to electrical
components, follow these steps:
1. In electrical box, place appliance circuit breaker
into OFF position.
2. Place a lock or other device on electrical box
cover to prevent someone from placing circuit
breaker ON.
3. Place a tag on electrical box cover to indicate
that appliance has been disconnected for
service and power should not be restored until
tag is removed by maintenance personnel.
4. Disconnect appliance power cord from electrical
outlet.
5. Place a tag on the cord to indicate that unit
should not be restored until tag is removed by
maintenance personnel.
Combination Oven Installation and Operation Manual
the
factory,
the
electrical
connection
Section 6
Maintenance
factory
or
33
Publicité
