The Control System Testing - Staufenbiel EDGE 540 Instructions De Montage

EN
Before getting started, bind your receiver with your transmitter. Please refer to your Transmitter
Manual for proper operation.
CAUTION: To prevent personal injury, DO NOT install the propeller assembly onto the motor
shaft while testing the control surfaces. DO NOT arm the ESC and do not turn on the transmitter
until the Transmitter Manual instructs you to do so.
TIPS: Make sure all control sticks on your radio are in the neutral position (rudder, elevator, aile-
rons) and the throttle in the OFF position. Make sure both ailerons move up and down (travel) the
same amount. This model tracks well when the left and right ailerons travel the same amount in
response to the control stick.
1. Move the controls on the transmitter to make sure aircraft control surface move correctly. Or
you have to reverse the corresponding switch on the TX front panel mechanically. See diagrams
below:
32

THE CONTROL SYSTEM TESTING

Bank Left
Bank Reft
Climb
Descend
Yaw Left
Yaw Right
AILERON
ELEVATOR
RUDDER
/ STEERING