Control Throws - Staufenbiel Outlaw Instructions De Montage

35
35
The assembly of the modell is now completed and you can start programming the transmitter.
Please check once again the servo direction.
Use the rudder throw and CG Information below.
Please note that all rudder throws are measured at the widest points.
Aileron
Elevator
Rudder
Now have some fun with the first flight of you new OUTLAW.
If you done all setting as written here in the manual you will have a fantastic and precise flying
modell and fun for many hours.
CG 165 -170 from lea-
ding edge of the wing to
the back measuered on
the upper wing.

CONTROL THROWS

▲ 55 mm / ▼ 45 mm
▲ 75 mm / ▼ 75 mm
◄ 90 mm / ► 90 mm
40% - 60% Expo to all control surfaces
THE END
Fasten the lower wings with the wing bolts or
use a rubber as shown on the picture.
Check the Center of Gravity (CG) and move
the battery if needed. The CG will be mea-
sured from leading edge to the back of the
upper wing.
During our test flights we reached best flying
performance with a CG of 170 mm.
EN
31