Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
At the end the ESC, the motor and the receiver needs to be built in. Start programming the model in
the transmitter. Connect all servo cables according to the transmitter manual and make sure that all
servo and rudder are working in right direction. We recommend 3 Flight modes. The rudder throws
are shown in the table. You will get good flying performance with these throws and the center of gra-
vity shown below.
Function
Aileron
Elevator (V-Tail)
Rudder (V-Tail)
Flaps
85 - 89 mm behind the leading edge against the fuselage.
Now enjoy the first flight with your new MANTIS. For extra high maneuverability flaps can be mixed to
the ailerons. We recommend about 50% admixture. Look forward to many hours with your MANTIS.
20
ASSEmBLY COmpLETION
CONTROL THROWS
Normal (Butterfly Bra-
ke)
▲ 13 mm, ▼ 6 mm
(▲ 16 mm)
▲ 16 mm, ▼ 11 mm
(▼ 4 mm)
▲ 18 mm, ▼ 9 mm
(▼ 25 mm)
CENTER OF GRAVITY
THE END
Afterwards drive the servos to the
electronic middle position. Hold the
halfs of the V-tail in neutral position
and tighten the grubscrew of the
linkage connector.
Flight mode
Thermal
0
0
0
▼ 4 mm
Speed
▲ 2mm
0
0
▲ 3 mm
Publicité
Table des Matières
