Staufenbiel EDGE 540 Instructions De Montage page 36

EN
36
4. Place self-locking nuts right-
ly into the inboard hex notch on
bottom of the spinner backplate
as picture shows. Cover the cover
plate on the propellers. Using the
longer screws (22mm) to secure
the cover plate with the propeller
and spinner plate tight enough as
the picture shows.
5. After the three screws' tightening complete, make
sure there is no gap between this propeller holder
plate.
6. Verifiy the status of the propeller installation com-
pleted.
7. Keyed the propeller assembly to the motor shaft,
make sure fit the assembly into the hex stage on the
shaft, it will help to hold the assembly in fixed position
when the engine contact. Install the spinner head to
the plate.