Publicité
Les langues disponibles
Les langues disponibles
Assembly and dismantling of the side runner frames
* Assemble the wire racks to the oven walls using the 2 screws (fig. 6.1).
* Slide into the guides, the shelf and the tray (fig. 6.2).
The rack must be fitted so that the safety notch, which stops it sliding out,
faces the inside of the oven; the guard rail shall be at the back.
* To dismantle, operate in reverse order.
Inside of oven
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm
water. Suitable proprietary chemical cleaners may be used after first
consulting with the manufacturers recommendations and testing a small
sample of the oven cavity. Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity surface.
Note
The manufacturers of this appliance will accept no responsibility for
damage caused by chemical or abrasive cleaning.
Let the oven cool down and pay special attention no to touch the hot
heating elements inside the oven cavity.
Drawer (some models only)
The drawer (fig. 6.3) comes out like
a normal drawer.
Do not store flammable material
in the oven or in the drawer.
Guard rail
Fig. 6.1
222
Stop notch
Fig. 6.2
Fig. 6.3
Publicité
