Burkert 8022 Mode D'emploi page 21

Type 8022
SettingandFunctions
Directly setting the value of the k factor:
noTE
as soon as the Free parameter has been accessed, the output used (current output or frequency
output) is frozen to the last measured process value until the new k-factor has been validated.
• Validate the parameter as soon as the K factor is set.
In the FrEE parameter, directly enter the K factor of the fitting used. Observe the K factor given in the operating
instructions of the fitting (e.g. of type S020, S030 or S070).
After the set K factor has been confirmed using the ENTER key, the value in the FrEE parameter is overwritten.
English
19