Operating Levels - Burkert 8022 Mode D'emploi

9.3.

Operating levels

For operating the flow transmitter / pulse divider there are 2 levels available: the Read level and the configuration
level.
level 1: r ead level
When the device is switched on, it is at the Read level. The flow rate measured by the connected sensor is
indicated.
A t this level use the arrow keys to successively read different values and define which of them stays displayed. The
values differ depending whether the device is operating as a flow transmitter or a pulse divider.
Flow transmitter
l / m
PV
25.5
PV Hz
25.5
PV mA
12.3
Figure 8: Level 1: Display options when operating as a flow transmitter or a pulse divider
level 2: configuration level
At this level, the settings for the device are made.
Figure 9: Level 2: Define the settings
16
Flow rate in liters/minute
Input frequency of the flow rate
sensor [Hz]
Output current [mA]
Unit = s et the unit for the flow rate
InP / Input = set the K factor of the fitting used
Out / Output = set the output signal
dAtA / Data = transfer of data from/to display and configuration unit
End = e nd configuration
Go back to Read level
English
Type 8022
SettingandFunctions
pulse divider
l / m
Flow rate in liters/minute
PV
25.5
Input frequency of the flow rate
PV Hz
sensor [Hz]
25.5
Output frequency [Hz]
Hz
25.5