Switching Between The Operating Levels; Main Menu Of The Configuration Level - Burkert 8022 Mode D'emploi

Type 8022
SettingandFunctions
9.3.1.

switching between the operating levels

When the device is switched on, it is at the Read level.
→
Press and hold the ENTER key (3 seconds) to switch to the configuration level.
→
Confirm End in the main menu loop using the ENTER key to return to the Read level.
level 1: read level
l / m
PV
25.5
Hz
mA
Figure 10: Switching between the operating levels
9.4.

main menu of the configuration level

→
Press and hold the ENTER key (3 s) to access the configuration level.
The following settings are possible:
Unit = set the unit for the flow rate, see chapter 9.4.1
InP / Input = set the K factor of the fitting used, see chapter 9.4.2
Out / Output = set the output signal, see chapter 9.4.3
dAtA / Data = transfer of data from/to the display and configuration unit, see chapter 9.4.4
Leaving the configuration level:
End = e nd the settings and go back to the Read level by pressing the ENTER key when End is
displayed.
> 3 s (long)
level 2: configuration level
Unit
InP
Out
dAtA
End
English
17