inventiv INV E1637 P Notice Originale D'utilisation page 61

Troubleshooting
Suspected malfunctions are often due to causes that the user can fix themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING!
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Unsatisfactory
result
Only perform the steps described within these
Possible cause
1. Not connected to power
supply
2. Power cord or plug is
defective
3. Other electrical defect to
the product
4. Lock-off button not
pressed
1. Extension cord not
suitable for operation with
this product
2. Power source (e.g.
generator) has too low a
voltage
3. Air vents are blocked
1. Cutting device is worn
2. Cutting material exceeds
capacity
3. Cutting height is incorrect
4. Wheels on different height
level
Solution
1. Connect to power supply
2. Check by a specialist
electrician.
3. Check by a specialist
electrician
4. Press the lock-off button first,
then the start lever
1. Use a suitable extension cord
2. Connect to another power
source
3. Clean the air vents
1. Replace with a new one
2. Only cut materials according
to capacity of the product
3. Adjust cutting height
4. Adjust the wheels on the
same height level
61