inventiv INV E1637 P Notice Originale D'utilisation page 42

Recommendation for class II products
The product should be supplied via a residual current
device (RCD) with a tripping current of not more than
30 mA.
Vibration and noise reduction
To reduce the impact of noise and vibration emission,
limit the time of operation, use low-vibration and low-
noise operating modes as well as wear personal
protective equipment.
Take the following points into account to minimize the
vibration and noise exposure risks:
1. Only use the product as intended by its design and
these instructions.
2. Ensure that the product is in good condition and
well maintained.
3. Use correct cutting device for the product and
ensure they in good condition.
4. Keep tight grip on the handles/gripping surface.
5. Maintain this product in accordance with these
instructions and keep it well lubricated (where
appropriate).
6. Plan your work schedule to spread any high
vibration tool use across a longer period of time.
42