inventiv INV E1637 P Notice Originale D'utilisation page 56

Maintenance
WARNING!
from the power supply and let the product cool down before
performing inspection, maintenance and cleaning works.
- Keep the underbody and cutting blade clean and free of debris. Remove
clippings from the discharge chute.
- Check all nuts and bolts for tightness before operation. After prolonged
use, especially in sandy soil conditions, the cutting blade will become
worn and lose some of its original shape. The cutting efficiency will be
reduced and the cutting blade should be replaced.
- Lubricate the cutting blade after each use to prolong the life span of the
blade and product Apply light machine oil along the edge of cutting blade.
Replace the cutting blade
WARNING!
Wear safety gloves when working on the cutting device and close
to it! Use proper tools to remove debris, e. g. a wooden stick!
Never use your bare hands!
Always use original spare parts for replacement. Only use
original spare parts. Part number is SMV 1489201 (for INV E1334
P), and SMV 1488214 (for INV E1637 P). Do not attach any other
type of cutting device!
The replacement of the cutting device should be done by
an experienced user! Rework or sharpening blades is not
recommended unless it is done by a repair service or a similarly
qualified specialist!
1. Loosen the bolt anticlockwise using a suitable wrench and remove it together with
cutting device
2. Replace the cutting device with a new one of the same type.
3. When re-attaching the cutting device onto the spindle, pay attention to correct
Always switch the product off, disconnect it
56