Frymaster 8195985 Guide D'installation Et D'utilisation page 29

Daily:
1. Preparation: When the Product Holding Device is cool (such as before the unit is
turned on in the morning), and with the ON/OFF switch in the OFF position,
remove the product drawer and water tray.
2. Cabinet Surfaces: Dampen a clean cloth with a solution of detergent and water
and wipe down all exposed metal surfaces. A Scotchbrite
scouring pad may be used to remove stubborn residue from metal surfaces.
3. Removable Parts: The water tray and product drawer can be washed in the sink.
Use a solution of detergent and water to clean all surfaces. A Scotchbrite
similar nylon scouring pad may be used to remove stubborn residue from metal
surfaces. Rinse residue off and thoroughly dry before placing back into the
Product Holding Device.
4. Reassembly:
a. Water Tray:
1. Reassemble the water tray.
2. Place the reassembled water tray back into the Product Holding Device
cabinet.
3. Fill the water tray to within ¼-inch (6mm) of top edge with fresh water.
Note: The PHD can be operated without water in the tray when a dry
product is being held.
4. Secure the tray by lifting onto the latch to lock in place.
b. Product Drawer:
1. Reassemble the product tray.
2. Slide the reassembled product drawer into the cabinet.
5. The Product Holding Device is now ready for future operation.
Product Holding Device
13
®
or similar nylon
®
or