Frymaster 8195985 Guide D'installation Et D'utilisation page 27

6. Changing Temperature Display: Fahrenheit to Celsius
1. Turn off power to unit.
2. Press and hold
3. Display is converted to Celsius. Reverse process to return to Fahrenheit display.
7. Operating
Morning:
a. Prepare unit by following instructions found in Chapter 4. If holding moist product, fill
the water tray before beginning daily operations. The degree of moisture in the cabinet
can be regulated with the vent/slide on the cabinet door. Note: The PHD can be
operated without water in the tray when a dry product is being held.
The Product Holding Device is designed to operate with separate upper and lower
b.
setpoints. Follow instructions in Section 5 to set or adjust setpoints.
c. Turn power switch ON. The Product Holding Device will begin heating to the setpoint
temperatures. LED 1 will light when the controller calls for heat.
Operator will be exposed to steam or very hot air emitting from the PHD when unit is
operating. Wear proper protective clothing when working with an operating PHD. Do
not place exposed face or hands near the Product Holding Device when opening or
d. Check the water tray periodically to ensure water tray is full. Note: The PHD can be
operated without water in the tray when a dry product is being held.
Product Holding Device
as the unit is turned back on .
DANGER
closing th Product drawer or water tray.
11