Publicité
!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF
ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
CONTENTS
Owner Manual
●
Charging Lead
40 Amp Fuse
30 Amp Fuse
●
●
20 Amp Fuse
10 Amp Fuse
●
●
4 Amp Fuse
2.5 Amp Fuse
●
●
Maxi Fuse Puller
●
Lift top tank assembly to reveal battery
compartment, ensuring you use the
handle grip provided.
Fit battery fuse (contained in start-up
pack) into the battery fuse holder as
illustrated.
(Fig. 1, 2, 3.)
Insert Key into ignition located on the
control panel.
NOTE: Wear suitable gloves when
inserting fuses.
1
Less Battery Models - Numatic International Ltd recommends using MK or Sonnenschein Batteries for the 8055 & 8072 machines
mentioned in this manual. For full battery specifications see page 22.
!
Turn the key to switch on the machine, set
lever to forward.
NOTE: DO NOT DEPRESS ACCELERATOR PEDAL WHILE SOFTWARE INITIALISES. The machine will not operate in reverse with the floor tool lowered. The seat is fitted with a
pressure sensor that disables the machine until an operator is seated.
8
www.numatic.co.uk
Battery
●
2 x Keys
●
Use handle grip when
raising or lowering the
2
ENSURE THAT NO METAL OBJECTS COME INTO CONTACT WITH BATTERY TERMINALS
WHILE THE BATTERIES ARE EXPOSED.
WHEN INSERTING THE FIRST FUSE YOU MAY NOTICE A SPARK, THIS IS NORMAL.
Set to slowest speed, depress accelerator and drive off the
palette using ramp provided.
top waste-tank.
Machine Set-up Guide
3
Once in a safe location switch off machine.
!
Fuse Location
!
Publicité
