Publicité
Machine Set-up Guide
Hose U-bend Clip
The U-bend in the hose prevents water spillage when the vacuum is switched off.
Refit vacuum hose to the floor tool when finished.
NOTE: DO NOT push the vacuum hose onto the
floor tool with the floor tool in the raised position.
Fitting the Floor Tool
NOTE: Raise floor tool before driving to the cleaning area.
The machine will not operate in reverse with the floor tool lowered.
Break-away Floor Tool
The floor tool design incorporates a safety knock-off feature, this allows it to safely disengage from its
mounting should it become caught on an obstruction during
forward movement.
Make sure you do not over tighten the retaining knobs.
Slide floor tool onto bracket.
10
www.numatic.co.uk
Tighten retaining knobs to finger tight and
attach hose.
Lower the floor tool.
Raise the floor tool.
Publicité
