Interventions On The Machine; Replacing Wheels - GGP ITALY SPA SD98-108 Manuel D'utilisation

The machine comes with a connector (1) for recharging; this is
connected to the corresponding connector for the special
"CB01" or "FIGHTER" maintenance battery-charger supplied
(if included) or available on request (
IMPORTANT
This connector must only be used for
connection to the "CB01" or "FIGHTER" maintenance bat-
tery-charger. For its use:
– follow the instructions in the relevant user manual,
– follow the instructions in the battery manual.

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain an evenly
cut lawn and reduce vibrations.
If the cut is uneven, check the tyre pressure.
9.2).
If this is not sufficient to achieve an even cut, please contact
your Dealer who will test and make the necessary adjustments
to the alignment of the cutting deck.

6.3.2 Replacing wheels

Stop the machine on flat ground and put a block under a load-
bearing part of the frame on the side that the wheel is to be
changed. The wheels are held by a snap ring (1) which can be
eased off with a screwdriver.
NOTE
If you have to replace one or both rear
wheels, make sure that any differences in their external
diameter does not exceed 8-10 mm; on the contrary, to pre-
vent an uneven cut it will be necessary to adjust the align-
ment of the cutting deck.
IMPORTANT
Before remounting the wheel, apply
grease to the axle. Put the snap ring (1) and supporting
washer (2) back in place.
2 1
EN 27