Brake Pedal; Drive Pedal - GGP ITALY SPA SD98-108 Manuel D'utilisation

4.22 SPEED CHANGE LEVER
This lever has seven positions for
the 5 forward speeds, the neutral
position «N», and reverse «R».
To go from one speed to another,
press the pedal (4.21) halfway and
shift the lever as shown on the
label.
WARNING!
Only shift into reverse when the
machine has stopped moving.
Hydrostatic transmission

4.31 BRAKE PEDAL

This pedal works the brake on the
rear wheels.

4.32 DRIVE PEDAL

This pedal engages drive in the
wheels and controls the
machine's forward and reverse
speeds.
– To engage forward drive, press
it towards «F» with your toe-
cap. As you increase the pres-
sure on the pedal, the speed of
the machine increases.
EN 14
4.22
R
N
1
2
3
4
5
4.31
N
F
4.32
R
– Reverse is engaged by pressing the pedal with the heel
towards «R».
– The pedal automatically goes into neutral «N» when
released.
WARNING!
Only shift into reverse when the
machine has stopped moving.
NOTE
If the drive pedal is used, whether
forwards or for reverse, the engine stops as soon as the
parking brake (4.4) is engaged.
4.33 HYDROSTATIC TRANSMISSION DISENGAGEMENT
LEVER
This lever has two positions:
«A» = Transmission
engaged: for all uses,
when moving and during
cutting;
«B» = Transmission dis-
engaged: this makes it
much easier to move the
machine by hand, with
the engine turned off.
IMPORTANT
To avoid damage to the transmission
unit, this operation must be carried out only when the
engine has stopped with the pedal (4.32) on position «N».
B
4.33
A