GGP ITALY SPA SD98-108 Manuel D'utilisation page 81

making sure that the
plug (3) is correctly fit-
ted into the hub seat.
Fit the dashboard
cover (4) clicking the
seven fasteners into
place.
Fit the steering wheel
(5) onto the hub (1)
with the spokes
directed towards the
seat.
Fit the spacer (6) and fasten the steering wheel in place using
the screws supplied (7), in the indicated order.
Fit the steering wheel cover (8) clicking the three fasteners
into place.
3.3 FITTING
THE SEAT
Mount the seat (1) on
the plate (2) using the
screws (3).
EN 10
8
7
6
5
1
2
3
3
3.4 ASSEMBLY AND CONNECTING THE BATTERY
The battery (1) is housed under the seat and secured by a
spring (2).
First connect the red wire (3) to the positive pole (+) and then
the black wire (4) to the negative pole (–), using the screws
supplied as shown.
Apply silicone grease to the terminals and check that the pro-
tective cap for the red wire (8) is in place.
IMPORTANT
ing to the instructions in the battery's manual (
IMPORTANT
tronic circuit board from cutting in, never start the engine
until the battery is fully charged!
WARNING!
guard (2) or with the battery incorrectly fixed in its
housing.
4
1
Always fully charge the battery accord-
To prevent the safety device in the elec-
Do not use the machine without the
1 2
6.2.5).
5 3