Using The Machine - GGP ITALY SPA SD98-108 Manuel D'utilisation

5.4 USING THE MACHINE

5.4.1 Starting
DANGER!
The engine must be started in an
open or well-ventilated area! ALWAYS REMEMBER THAT
EXHAUST GASES ARE TOXIC!
To start the engine:
– open the fuel stopcock (1);
– shift in the gear into neutral («N»)
( 4.22 or 4.32);
– disengage the blades (
– apply the parking brake on sloping
ground;
– for cold starting, operate the
choke ( 4.2 or 4.2a);
– if the engine is already warm, position the lever between
«SLOW» and «FAST»;
– put in the ignition key and turn to «ON» to make electrical
contact, then turn to «START» to start the engine;
– release the key once the engine has started.
When the engine has started, move the throttle to «SLOW».
IMPORTANT
The choke must be closed as soon as
the engine is running smoothly. Using it when the engine is
already warm can foul the spark plugs and cause the engine
to run erratically.
NOTE
If there are engine starting problems, do
not insist as you can risk running the battery flat and flooding
EN 18
4.5);
the engine. Turn the key to «OFF», wait for a few seconds
and then repeat the operation. If the malfunction persists,
refer to the engine manual and chapter «8» in this manual.
IMPORTANT
devices prevent the engine from starting if safety require-
ments have not been met (
In these cases, once the situation has been corrected, the
key must first be turned back to «OFF» before the engine
can be restarted.
1
5.4.2 Starting and moving without mowing
WARNING!
for use on public roads. It has to be used (as indicated
by the highway code) in private areas closed to traffic.
When moving the machine:
– disengage the blades;
– bring the cutting deck to the highest position (position «7»);
– put the accelerator control between the «SLOW» and
«FAST» positions.
Mechanical transmission
Push the pedal down as far as possible (
the gear change lever into 1st gear (
Keep the pedal pressed down and release the parking
brake. Slowly release the pedal to shift from «brake» to
Always bear in mind that the safety
5.2).
This machine has not been approved
4.21) and move
4.22).