GGP ITALY SPA SD98-108 Manuel D'utilisation page 82

3.5 FITTING THE STONE-GUARD
Inside the stone-guard (1), fit the spring (2) by inserting the ter-
minal (2a) into the hole and turning it so that both the spring
(2) and the terminal (2a) are securely positoned in their seat-
ings.
1 2a
2
Position the stone-guard (1) in line with the cutting deck brack-
ets (3). Using a screwdriver, turn the second terminal (2b) of
the spring (2) to bring it outside the stone-guard.
2b 2
Fit the pin (4) in the holes on the brackets (3) and on the
stone-guard, so that it passes thrugh the coils of the spring (2)
and the drilled end comes out of the inner most bracket.
Fit the cotter pin (5) in the hole (4a) of the pin (4) and turn the
pin until the two ends (5a) of the split pin can be bend (using
pliers), so that it cannot slip out and let the pin fall out (4).
2
2b
1
3
1
4
3
5
4a
4
WARNING!
Check that the spring works correctly
and keep the stone-guard securely lowered. Make sure
that the pin is fitted properly to prevent it from falling
out accidently.
3.6 REPOSITIONING THE ANTI-CHIPPING WHEELS
For transport reasons, the
anti-chipping wheels (1) are
fastened on the top hole. In
order for them to work
properly, the anti-chipping
wheels (1) must be reposi-
tioned in the hole which is
most suited for the type of
ground ( 5.4.5).
2
5a
1
EN 11