Replacing Wheels; Interventions On The Machine - GGP ITALY SPA 72 Manuel D'utilisation

IMPORTANT
Recharging must be done using a bat-
tery charger at constant voltage. Other recharging systems
can irreversibly damage the battery.
The machine has a connector (1) for recharging, to be con-
nected to the corresponding connector of the special "CB01"
or "FIGHTER" maintenance battery-charger supplied (
included) or available on request (
IMPORTANT
This connector must only be used for
connection to the "CB01" or "FIGHTER" maintenance bat-
tery-charger. For its use:
– follow the instructions given in the relative instruction
booklet,
– follow the instructions given in the battery booklet.

6.4 INTERVENTIONS ON THE MACHINE

6.4.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven, check the tyre pressure.
EN 28
if
9).
If this is not sufficient to achieve an even cut, please contact
your Dealer for the adjustment of the alignment of the cutting
deck.

6.4.2 Replacing wheels

Stop the machine on flat ground
and put a block under a load-
bearing part of the frame on the
side that the wheel is to be
changed.
The wheels are held by a snap
ring (1) which can be eased off
with a screwdriver.
NOTE
If you have to replace one or both rear
wheels, make sure that any differences in their external
diameter does not exceed 8-10 mm; on the contrary, to pre-
vent an uneven cut it will be necessary to adjust the align-
ment of the cutting deck.
IMPORTANT
Before remounting the wheel, apply
grease to the axle. Put the snap ring (1) and supporting
washer (2) back in place.
6.4.3 Changing and repairing tyres
All puncture repairs or replacements will have to be carried out
by a tyre repair expert in accordance with the methods for the
kind of tyre used.
2 1