Publicité
Side Mounting
The L-shaped bracket (P/N 9699298) is available as an option.
NOTE
See the following figure.
1
2
3
4
5
6
7
8
9
TV 1001 Navigator User Manual / 87-900-945-01(L)
Place the L-shaped bracket on the controller, with the pump cable toward
the bracket, and fix it by means of the three socket head screws M5, the
washers and the nuts. The 6 holes on the bracket allows to mount the
controller with the rotation angle that you like;
Turn the pump upside-down;
Place the bracket on the pump bottom (the hole on the bracket has the
same diameter as the pump bottom flange);
Screw a little bit the three screws M6 in the holes on the pump bottom;
Rotate the bracket until the controller is on the chosen position;
Tighten the screws properly;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock signal to
start the pump.
Technical Information
TV 1001 Controller Installation
17
295/310
Publicité
