Publicité
TV 1001 Controller Installation
The controller can be mounted in two position:
To install the controller execute the following procedures.
Bottom Mounting
See the following figure.
1
2
3
4
5
6
7
TV 1001 Navigator User Manual / 87-900-945-01(L)
bottom mounting (as per the complete system)
side mounting.
Turn the pump upside-down;
Place the three fixing blocks with the through holes toward the inside, and
fix them with the three M6 screws to the pump bottom;
Place the controller on the blocks, with the pump cable toward the pump
body;
Fix the controller to the blocks by means of the three socket head screws
M5;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock signal to
start the pump.
Technical Information
TV 1001 Controller Installation
17
293/310
Publicité
