Fixing The Unit In Place; Installing Roof Thickness Adapters; Fixing The Air Distributor In Place - Truma Aventa comfort Mode D'emploi

Route the power supply cable to the connection point (extend
the cable with however many Wago terminals you need if
necessary).

Fixing the unit in place

Screw the two brackets (marked with an arrow pointing in the
vehicle's direction of travel) to the unit using the 4 M6 x 70
screws (with sealant) included in the scope of supply (tighten-
ing torque).
Torque 1.8 Nm
M6 screws must be used for roof thicknesses of more than
50 mm (length = roof thickness + 30 mm) and tensile strength
of 8.8. The screws must be coated with low-strength sealant
(e.g. Loctite).
22
1,8 Nm

Installing roof thickness adapters

Base ring (1) and dependent upon the roof thickness, slide
the roof thickness adapters (2 or 2+3, included in scope of
delivery) for roof thickness of 25 to 50 mm as far as possible
into the air distributor. Use additional 10 mm roof thickness
adapters (see accessories) if the roof is thicker. Maximum roof
thickness 110 mm.
3
2
1

Fixing the air distributor in place

Connect the cable from the air distributor to the electronics box.
Screw the air distributor (arrow pointing in the vehicle's direc-
tion of travel) to the brackets with 6 screws M6 x 12 mm.
25 – 30 mm = 1
31 – 40 mm = 1+2
41 – 50 mm = 1+2+3