Publicité
Les langues disponibles
Les langues disponibles
3.
Remove the fixing screws of the condensate drain pan Fig. 14.
1
4.
Remove the condensate drain pan Fig. 15.
5.
Remove the screws fixing the heat exchanger Fig. 16.
6.
Remove the heat exchanger Fig. 17.
2
7.
At the end of this operation, break down with a hummer the perforating sections on the
side of the unit accordingly to the new position of the water connections and mount
back all components in the opposite sequence.
3
8.
Mount back the electric box on the same side of the water connections, paying
particular attention not to prejudice the conformity of the electric cabling.
4
5
6
7
Fig. 12
8
9
10
Fig. 15
+
7.4.3 REPLACING THE HEAT EXCHANGER
For maintenance operations turn off the unit and wait for some minutes. Always use protection gloves.
For the replacement of the heat exchanger operate as descripted in Par. 7.4.2 until Fig. 17.
Replace the heat exchanger and mount the components back in the opposite sequence.
In case of other problems, contact the area distributor or EURAPO service department.
44
Fig. 13
Fig. 16
Fig. 14
Fig. 17
Publicité
