Inserting The Milk Carafe; Removing The Milk Carafe; Dispensing Frothed Milk Based Coffee Beverages - Gaggia Milano MAGENTA PRESTIGE RI8702 Mode D'emploi

4219-465-03661 MAN. GAG.MAGENTA PRESTIGE 120V EN-FR Rev 01.indd 21
2 Pour the milk into the milk carafe: the milk level must be between the minimum
(MIN) and the maximum (MAX) level indicators shown on the carafe. Place the
lid back.

Inserting the milk carafe

If installed, remove the water dispensing spout:
1 Press the two side buttons to unlock the dispensing spout and lift it slightly;
2 Pull the water dispensing spout to remove it.
3 Slightly tilt the milk carafe. Insert it all the way into the guides of the machine.
4 Push the carafe downwards while rotating it at the same time until it locks onto
the drip tray.
Note: Do not force the carafe while inserting it.

Removing the milk carafe

Rotate the carafe upwards until it is naturally released from the insert in the drip
tray. Then, remove the carafe.

Dispensing frothed milk based coffee beverages

Tip: use only cold milk (at a temperature of 5 °C approx.) and with at least a 3%
protein content so as to obtain a perfect milk foam. You can use either whole milk
or semi-skimmed milk. Also, you can use skimmed, soy or lactose-free milk.
1 Pull out the milk dispensing spout to the right up to the icon.
Note: if the milk dispensing spout has not been pulled all the way out, milk may not
be properly frothed.
2 Place a cup under the open milk dispensing spout.
3 Press the HOME button and choose the desired beverage from the menu.
HOME
- Press the button corresponding to the desired beverage.
- Press the START/STOP
beverage.
button to start dispensing the selected
START/STOP
English
21
21/01/2021 12:18:49