Installing The Monitor - SOMFY V100 Notice D'installation Et D'utilisation

EN
[1]. Fix the monitor mounting plate to the wall.
Important: Ensure the direction of fitting is correct by positioning
the arrow upwards ("UP" facing upwards) as indicated on the
illustration.
Note: You can also use the mounting screws provided in standard
flush-mounting boxes; the distance between the plate mounting
holes is the same.
[2]. Remove the DC connector from the rear of the monitor and
connect the cable from the power plug to this connector: black
wire with white lines on the le (+) and black wire on the right (-).
[3]. Connect the power plug connector to the DC input at the rear of the
monitor in the direction indicated in the illustration (screws at the
bottom); the direction in which the wires are connected to the power
plug is important.
Important: It is essential to use the power plug
provided to supply the monitor.
Prepare the monitor for connection to the door station by
connecting a 2-wire cable to connector P1 at the rear of the
monitor.
If you wish to install a second monitor, prepare the connection for
this monitor by connecting 2 wires to the P2 connector at the rear
of the monitor, then refer to the guide for the second monitor for
additional information on its wiring.
[4]. Clip the monitor onto its mounting bracket by first positioning the
top of the monitor on the station, then the bottom.
Note: Position the power plug wires between the mounting
bracket and the monitor.
7

4. INSTALLING THE MONITOR

1
2
3
4
Monitor
To the door
station
Finish all of the cabling before connecting the monitor to
the mains.
Video door phone V100
60 mm
Power plug wires
To a second
monitor
(optional)
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.