haacon 4336.16 Manuel D'instructions page 39

6. MoUnting
3.1 3 2 2.1 2.2 4
9 6 5
fig. 6-1 – Overview of the roller with drawbar
The following designations are used in these operating
instructions.
1 Drawbar
1.1 Assembly aid (socket wrench removed in the image)
2 Fastening element
2.1 Locking screw
2.2 Fitting
3 Bolt
3.1 Linchpin
4 Direction locking device
5 Parking brake
6 Safety bracket
7 Support rollers
7.1 Locking pin
8 Socket pin
9 Socket pin for drawbar
10 12
10.1
10.2
fig. 6-2 – Overview of the drawbar
10 Drawbar tube
10.1 Socket pin
10.2 Socket pin for securing the tie rod
11 Tie rod
11.1 Diagonal struts
11.2 Outrigger
12 Parking support
12.1 Fastening fixture
13 Handles
094343_m_gb_crllstz_v
8 1.1 1
7 7.1
13 10.1
11.1 11
haacon hebetechnik gmbh – Telefon +49 (0) 9375 - 84-0 . Fax +49 (0) 9375 - 8466
6.1 safety instructions
– First read the operating instructions.
– Mounting only by specialist personnel!
– Unauthorised persons are not permitted within a
5 m radius around the device while transport is in
progress.
– Installation must be carried out by 2 people.
– Observe the safety instructions, chap. 2.
– Before attaching, check that the container is suitable
for this purpose.
– Always move the parts of the roller set slowly,
and wherever possible consecutively.
– Pay attention to crushing and shear points.
– Wherever possible, make preparations for each step
in advance, so that you only need to stand under
the container for a short time.
– When moving the roller, make sure that it does not
tip over. Move the roller slowly and pay attention
to obstacles and unevenness of the ground.
– Secure all connecting elements with the connectors
provided.
– Once installation is complete, and before each
transport operation, check all rollers and fastening
elements for the correct seating.
6.2 Moving, picking up and setting down the wheel unit
When picking up and setting down the wheel unit type 4336.16,
make sure that the safety bracket and the tube on the roller are
properly aligned. (–> fig. 6-3)
12.1
– The roller may only be moved, picked up and set down
using the steering rod.
– The direction locking device must be engaged in
11.2
order to do so (–> chap. 6.6)
– Set the roller down on the safety bracket.
– Always move the roller slowly, or there is a risk
of tipping.
– Never hold the roller by the safety bracket. Risk of
crushing!
fig. 6-3
5