Hypertherm Powermax105 SYNC Mode D'emploi page 9

Loosen the rear panel of the plasma power supply
1. Remove the end panel bracket
that you must first remove.
2. Put the fan side of the plasma power supply on a clean, dry, and flat surface.
3. Remove the screws
Some models have 2 screws on the bottom of the plasma power supply, and other models have
3 screws on the rear panel instead.
4. Move the bottom of the rear panel
access to the power cord inside the plasma power supply. Use a blade screwdriver to carefully
pry the rear panel away from the bottom of the plasma power supply.
Powermax105 SYNC Field Service Bulletin
All manuals and user guides at all-guides.com
. Some models have 2 screws
1
2
that attach the rear panel to the bottom of the plasma power supply.
3
off of the bottom of the plasma power supply to get
4
810420
Power Cord and Strain Relief Replacement
on the end panel bracket
2
2
1
3
4
4
3
9