Hypertherm Powermax105 SYNC Mode D'emploi page 18

Power Cord and Strain Relief Replacement
3. Fold the top of the component barrier
the top edge of the power PCB, inside the
plasma power supply frame and under the
end panel bracket.
4. Make sure that all of the wires that are
connected to the power PCB are behind the
component barrier.
5. Put the cover
Do not pinch any wires.
6. Install the 16 screws
supply cover. Tighten the screws to 1.7 N·m
(15 lbf·in).
Connect to electrical power
The power cord does not come with a plug.
Connect the power cord to the line-disconnect switch.
For more information about connecting to electrical
power, refer to the Powermax65/85/105 SYNC
Operator Manual (810470).
18
All manuals and user guides at all-guides.com
on the plasma power supply.
4
on the plasma power
5
onto
3
3
810420 Field Service Bulletin
4
5
Powermax105 SYNC