Hypertherm Powermax105 SYNC Mode D'emploi page 13

Attach the strain relief
1. If the retaining nut
2. On the outside of the plasma power supply, put the strain relief
the plasma power supply. If your model has a strain relief adapter
the adapter.
3. On the inside of the plasma power supply, install the hex nut
has a washer
Powermax105 SYNC Field Service Bulletin
All manuals and user guides at all-guides.com
4
4
5
is on the strain relief
1
, first put the washer on the strain relief. Tighten the hex nut with your hand.
5
810420
Power Cord and Strain Relief Replacement
2
3
, remove the retaining nut.
2
in the hole in the rear panel of
2
3
on the strain relief. If your model
4
2
1
, first put the strain relief in
13