Hypertherm Powermax105 SYNC Mode D'emploi page 16

Power Cord and Strain Relief Replacement
Install the rear panel of the plasma power supply
1. Put the fan side of the plasma power supply on a flat surface.
2. Push the rear panel
3. Install the screws
models have 2 screws on the bottom of the plasma power supply, and other models have
3 screws on the rear panel instead.
4. Put the plasma power supply in an upright
position.
5. Put the end panel bracket
your model requires screws to attach the end
panel bracket, install the 2 screws
removed previously.
16
All manuals and user guides at all-guides.com
onto the bottom of the plasma power supply.
1
that attach the rear panel to the bottom of the plasma power supply. Some
2
into position. If
3
that you
4
1
1
2
4
810420 Field Service Bulletin
2
4
3
Powermax105 SYNC