Hypertherm Powermax105 SYNC Mode D'emploi page 17

Install the component barrier and plasma power supply cover
1. Push in the sides
component barrier so that the
component barrier bends out
slightly down the center.
2. Put the sides of the component
barrier inside the plasma power
supply frame
Powermax105 SYNC Field Service Bulletin
All manuals and user guides at all-guides.com
WARNING
SHOCK HAZARD
You can get a serious electric shock if you touch exposed plasma power
supply components. Electric shock can seriously injure or kill you.
You must install the component barrier and the plasma power supply cover.
Never operate the plasma power supply unless the component barrier and the
plasma power supply cover are in position.
WARNING
SHOCK HAZARD
You can get a serious electric shock if you touch exposed plasma power
supply components. Electric shock can seriously injure or kill you.
You must install the component barrier and the plasma power supply cover.
Never operate the plasma power supply unless the component barrier and the
plasma power supply cover are in position.
of the
1
.
2
810420
Power Cord and Strain Relief Replacement
1
2
17