Hypertherm Powermax105 SYNC Mode D'emploi page 11

Remove the power cord
1. Remove the screw
2. Use an offset Phillips® screwdriver to loosen the screws
the top of the power switch.
3. Pull the 3 power wires from the power switch.
4. On the outside of the plasma power supply, remove the strain relief retention nut
strain relief. Move the retention nut away from the plasma power supply.
5. Remove the power cord.
CSA: From the outside of the plasma power supply

wires through the strain relief in the rear panel.
CCC/CE: From the inside of the plasma power supply

length of the power cord through the strain relief in the rear panel.

CCC/CE models have ferrite cores
ground wire. To maintain CCC/CE certification, install a CCC/CE power
cord kit.
Powermax105 SYNC Field Service Bulletin
All manuals and user guides at all-guides.com
1
that attaches the ground wire to the heatsink.
1
810420
Power Cord and Strain Relief Replacement
2
4
6
that attach the 3 power wires
2
, pull the power cord and power
5
, pull the power wires and the full
6
7 on the power wires and the
3
CCC/CE
7
CSA
5
to
3
from the
4
11