Burkert 8695 Guide Rapide page 21

ElectricalInstallation
9.3. display elements 24 V dc
Fig. 10: Display elements 24 V DC
led state
End position LED green on
End position LED yellow on
LED Valve yellow on
Status LED yellow flashing
flickers
Tab. 3: Display elements 24 V DC
note!
damage or malfunction due to penetration of dirt and humidity!
• To observe protection class IP65 / IP67, screw the transparent
cap in all the way.
Color setting ex works. Can be set via jumper (see "Fig. 10").
2)
All manuals and user guides at all-guides.com
Type 8695
End position LED green
Jumper for assignment of
end position LEDs
Status LED yellow
End position LED yellow
Valve LED yellow (pilot valve)
End postion bottom
End postion top
2)
Pilot valve is actuated
Teach function is running
Puck PCB not available
9.4. e lectrical installation as interface
9.4.1. c onnection with circular Plug-in
connector M12 x 1, 4-pole, male
Fig. 11: Connection with circular plug-in connector, AS-Interface
pin designation
2)
1 Bus +
2 NC
3
Bus –
4 NC
Tab. 4: Pin assignment of circular plug-in connector for AS Interface
→
Connect the control head according to the table.
The Teach function can now be used to automatically determine
and read in the end positions of the valve (description of the Teach
function see chapter "10. Teach function").
For the bus variant AS Interface, the Teach function can also
be started via the bus protocol.
Pin 3:
Pin 4:
Bus –
NC
Pin 1: Pin 2:
Bus +
NC
configuration
AS Interface bus line +
not used
AS Interface bus line -
not used
english
17