Burkert 8695 Guide Rapide page 13

7. insTallaTion
Only for control head without pre-assembled process valve.
7.1. safety instructions
Danger!
risk of injury from high pressure!
• Before dismounting pneumatic lines and valves, turn off the
pressure and vent the lines.
risk of electric shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations
for electrical equipment!
Warning!
risk of injury from improper installation!
• Installation may be carried out by authorized technicians only
and with the appropriate tools!
risk of injury from unintentional activation of the system and
an uncontrolled restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
All manuals and user guides at all-guides.com
Type 8695
Installation
7.2. installation of the control head on
Process Valves of series 21xx
Procedure:
When the control head is being installed, the collets of the
pilot air ports must not be fitted to the actuator.
→
Align the puck holder and the control head until
1. the puck holder can be inserted into the guide rail of the
control head (see "Fig. 4") and
2. the supports of the control head can be inserted into the
pilot air ports of the actuator (see also "Fig. 5").
note!
damaged printed circuit board or malfunction!
• Ensure that the puck holder is situated flat on the guide rail.
Supports
Fig. 4: Aligning the puck holder
english
Guide rail
Puck holder
11