Publicité
Les langues disponibles
Les langues disponibles
Maintenance
WARNING
Do not repair or modify to this device.
WARNING
Always remove the plug from the socket before you start maintenance!
Repairs and inspections must be carried out by a EUROM authorized professional. If the
device, electric cable and/or electric plug are damaged, they should be replaced by the
manufacturer or its service employee or persons with similar qualifications to prevent risks.
Perform the following maintenance tasks after every use:
•
Carefully remove dust, sand or other dirt from the connections (nozzle, extension lance,
jet gun, high-pressure hose and water inlet).
•
Remove the nozzle from the extension lance. Regularly clean the nozzle with the supplied
pin. Flush it thoroughly (against the direction of the high-pressure jet).
Perform the following maintenance tasks regularly:
•
Regularly Vaseline the O-rings of the connectors to prevent them from drying out.
•
Clean the water inlet filter.
Grease O-rings
1.
Pull the nozzle (Figure 5, pos. 4 or 5) from the
extension lance (Figure 5, pos. 1).
2.
Apply Vaseline to the O-ring of the nozzle
(Figure 15, pos. 1).
Figure 15
45
Publicité
