EUROM Force 1801 Mode D'emploi page 43

Change jet angle
CAUTION
The jet angle can only be changed of the adjustable nozzle. The turbo nozzle
and floor cleaner have a fixed jet angle.
1. If applicable, release the trigger
(Figure 6, pos. 2).
2. Lock the safety lock under the trigger
(Figure 6, pos. 1).
3. Rotate the head of the nozzle
(Figure 13, pos. 1) to change the jet angle:
•
for a smaller (more powerful jet) turn it
clockwise (Figure 13, pos. 2).
•
for a bigger (less powerful jet) turn it anti-
clockwise (Figure 13, pos. 1).
4. Unlock the safety lock under the trigger.
After operation
WARNING
If the device is off, left-over in the device can still be under high pressure.
CAUTION
•
•
•
1. Release the trigger (Figure 6, pos. 2).
2. Lock the safety lock under the trigger (Figure 6, pos. 1).
3. Switch the device off (Figure 4, pos. 12).
4. Pull the power plug out of the socket (Figure 4, pos. 9).
5. Wind the power cable.
6. Place the power cable on the bracket (Figure 4, pos. 1).
7. Close and disconnect the water supply.
8. Unlock the safety lock under the trigger.
9. Hold the jet gun with both hands.
10. Squeeze the trigger to drain the jet gun.
11. Unscrew the high-pressure hose (Figure 5, pos. 6) from the high-pressure outlet
(Figure 4, pos. 5).
12. Disconnect the high-pressure hose from the jet gun by pressing the button
(Figure 6, pos. 4).
Do not use the power cable to unplug or carry the device.
Do not wind the power cable too tightly or in sharp angles.
Do not wrap the power cable around the device.
Figure 13
43